END Mill & Drill Cutter

1. Install the power cord on the cutter.

2. Put the machine on a hard, level surface, then install the handle on the base.

***as shown on diagram #1

3. Lock the valve connector, then insert the pressurized blast connector into the air pressurized cooling system.

***as shown on diagram #2

4. Select the proper wheel and diameter of end mill drill Ø3mm~Ø16mm, put the end mill (drill) horizontally into the groove from right to left. Adjust the proper length for cut and tighten the base with Ø10mm Allen Key.

Note: Make sure the end mill (drill) is locatched in V-groove.
***as shown on diagram #3

5. Switch on the machine.

6. Switch on the cooling system.

Note: The usage life will be decreased if don't switch on the cooling system.
***as shown on diagram #4

7. Hold and raise the handle to cut off the end mill (drill).

***as shown on diagram #5
7-1. Touch the wheel with a slight push motion.
7-2. Be sure with very slight push motion during cutting process, don't be fast or slow at will.
7-3. To avoid the material fly away, be sure with very slight push motion while the end mill (drill) is going to be cut off.

8. Switch off the machine.

9. Switch off the cooling system.

10. Loosen the base with 10mm Allen Key, then take out the end mill (drill)

***as shown on diagram #6

11. Be sure to do every cleaning and maintenance well to maintain the usage life.

Note: Please switch off the machine while replacing the wheel to ensure the security!