Body Alignment: The body can be aligned by a cam activated support tool that pushes out the end.
Initial Tension: This is controlled by the depth of the cam activated coiling tool.
Straight leg formation: It can be done by moving the coil tool up and down.
Two types of cut off: Rotational cutting and mandrel cut.
Turn control: Magnetic touch sensor controls the number of turns precisely.
Four step separator: Assures precision intermittent motion at high speeds.
Two grips: One grips over the body portion. The other is to insert a blade between the coils.
Synchronous bending: Bending both ends synchronously will give accurate end angles.
Automatic selection: Two sensors inspect both hooks and sort for good and bad springs.
Automatic stop functions for safety operation by preset counter, decoiler fail, invalid cut, magnetic touch and bad spring counter.