What is a boring head used for?

Boring head

Boring Head
Jump to navigationJump to search
Boring heads are used to create large diameter holes when tolerances do not allow for a drill bit or do not have a large enough drill bit or reamer. A boring head can also be used to enlarge holes, or adjust hole centerlines in certain instances.

For a smooth finish remove 0.002 inches on the final pass. Use cutting oil to cool and lubricate tool.

Be sure all set screws are tight before operation. Be sure boring bar has a clearance to fit into hole when boring. Remove Allen wrench before turning the mill on. Double check mill speed before operation.

Boring head

Model ID:BHC2


  • Inch/Metric graduation div. 0.0005" / 0.01mm.

  • Inch/Metric standard is available.


Product Category


TEL : 886-2-26818596

FAX : 886-2-26818516

No. 7, Lane 341, Sec. 1, Bau An St., Shu Lin Dist., New Taipei City 238, Taiwan

Website : www.gin-chan.com


EZB2B.com uses cookies,IP to collect data and continually improve the website. By continuing to use this website, you must agree to the use of cookies and IP.